Mike T
Articles
-
Why do I have to power cycle my GT784WN to get Internet access?
This is typically caused by DSL signal issues. To check the DSL signal follow these instructions. In your Address Bar, where you would normally type a website, erase everything. Then type in the n...
-
How do I configure multiple different wireless networks or create a guest wireless network on my GT784WN?
From a computer connected by ethernet, open browser\type in the Address Bar 192.168.0.1 and hit enter. Click on Wireless Setup To your left, click on the "Multiple SSID" link. Click the drop down...
-
Why is my internet light red?
A red internet light indicates that you have connected to the internet but the PPP username and PPP password that was entered into Actiontec Gateway is incorrect and your ISP (Internet Service Prov...
-
How to bridge the GT784WN to be used as a modem only
You should not connect the second router to the unit unless you bridge it first to avoid subnet and NAT issues.To bridge the unit\connect directly to the unit by Ethernet.Open browser\type 192.168....
-
What is the default IP address for accessing the GT784WN?
The default IP address for accessing most of the Actiontec Modem and Routers is "192.168.0.1".
-
Is the GT784WN affected by the KRACK Vulnerability?
The GT784WN does not support repeater mode or 802.11r FT. So it is not affected by the KRACK vulnerability. So no firmware update is required. But you will need to make sure that your wireless devi...
-
How can I track what websites have been visited on my network?
The GT784WN has the ability to keep track of what websites are being visited but the users connected to it. However, it is not enabled by default. To enable this feature you will need to follow the...
-
GT784WN Wall Mount Template
To download or view the latest version of the GT784WN Wall Mount Templete please use the link below.
-
How do I change the default IP address of the GT784WN?
From a computer connected to the unit by ethernet, open browser\type in the address bar 192.168.0.1 and hit enter Click on Advanced Setup\to your left, click on LAN IP and DHCP settings Set the mo...
-
How to setup the GT784WN for a block of static IP's
To configure your Actiontec DSL gateway for use with a Static IP block from your internet provider, you will need to contact your ISP and obtain the following information: a) Your PPP username and ...